Radon is a naturally occurring radioactive gas that can enter a home from the soil below it. You cannot see or smell it, so a test is the only way to learn what is in your home.
Why and when to test
The U.S. EPA and the U.S. Surgeon General recommend testing all homes below the third floor for radon. Any home can have a radon problem, including new and old homes, well-sealed and drafty homes, and homes with or without basements.
You cannot predict your radon level from state, local, or neighborhood measurements. Homes next to each other can have different indoor radon levels, so a neighbor's result does not stand in for your own test. Our guide to why testing matters covers the reasoning in more detail.
EPA also suggests testing again in a few situations:
- You start using a lower level. If you begin living on a lower level of your home, such as a basement, test that level.
- You renovate. Major renovations can change radon levels, so test again after the work is finished.
- Your result was below 4.0 pCi/L. Even then, EPA says you may want to test again sometime in the future.
Short-term and long-term tests
There are two general ways to test, and the main difference is how long the device stays in your home.
- Short-term tests (2 to 90 days). These stay in your home from two days to 90 days, depending on the device. Charcoal canisters, alpha-track detectors, electret ion chambers, continuous monitors, and charcoal liquid scintillation detectors are most commonly used. Because radon levels change from day to day and season to season, a short-term test is less likely than a long-term test to show your year-round average.
- Long-term tests (more than 90 days). These stay in your home for more than 90 days. Alpha-track and electret detectors are commonly used. A long-term test is more likely to show your home's year-round average radon level.
Most people start with a short-term test because it is the quickest way to get a result. Compare the options in our guides to radon test kits and radon detectors and monitors.
Where to place a test
EPA gives these placement guidelines for a test device:
- Level of the home. Use the lowest lived-in level. That is the basement if it is used often, otherwise the first floor.
- Type of room. Choose a room used regularly, such as a living room, playroom, den, or bedroom. Do not place the test in a kitchen or bathroom.
- Height and surroundings. Place the kit at least 20 inches above the floor, in a spot where it will not be disturbed, away from drafts, high heat, high humidity, and exterior walls.
- Timing and lab. Leave the kit in place for as long as the package says. When the test is finished, reseal the package and send it to the lab named on the package right away. Results usually arrive within a few weeks.
Closed-house conditions
For a short-term test, EPA asks you to close your windows and outside doors and keep them closed as much as possible during the test.
- Fans that may run. Heating and air conditioning fans that recirculate air may be operated. Fans that are part of a radon reduction system, and small exhaust fans that run only for short periods, may also run.
- Fans to avoid. Do not operate fans or other machines that bring air in from outside.
- Short tests of 2 or 3 days. Close windows and outside doors at least 12 hours before the test begins. Avoid running these short tests during unusually severe storms or periods of unusually high winds.
These conditions are written for short-term tests. For a longer test, follow the instructions that come with the device.
What your results mean
EPA action level: 4.0 pCi/L. EPA recommends fixing a home when the radon level is 4.0 pCi/L (150 Bq/m3) or higher. EPA also recommends considering a fix when the level is between 2 and 4 pCi/L, because there is no known level of radon exposure that is free of risk.
WHO reference level: 2.7 pCi/L. The World Health Organization recommends a national reference level of 100 Bq/m3 (2.7 pCi/L) where possible, and says a country's reference level should not exceed 300 Bq/m3 (8.1 pCi/L).
For comparison, EPA estimates that the average indoor radon level in U.S. homes is about 1.3 pCi/L, and the average outdoor level is about 0.4 pCi/L.
EPA recommends these testing steps:
- Take a short-term test. If the result is 4.0 pCi/L or higher, take a follow-up test to be sure.
- Follow up. Use a long-term test for a better picture of your year-round average, or a second short-term test if you need results quickly. If your first short-term result is more than twice the action level, take the second short-term test right away.
- Decide. After a long-term follow-up, fix your home if the result is 4.0 pCi/L or higher. After a second short-term test, consider fixing your home if the average of the two tests is 4.0 pCi/L or higher.
If you need to fix your home, read about how radon mitigation works. To see how radon potential differs across the country, visit radon levels by state and ZIP code, and remember that area data does not predict your own home.
Frequently Asked Questions
How long does a radon test take?
It depends on the device. A short-term test stays in your home from 2 to 90 days, and a long-term test stays for more than 90 days. After a mail-in kit is finished, the lab typically returns results within a few weeks.
Do I need to test if my neighbor already did?
Yes. Radon levels can differ between homes that sit side by side, so a neighbor's result does not tell you what is in your home. EPA recommends testing every home below the third floor.
What should I do after a result below 4.0 pCi/L?
Your result is under the EPA action level, but EPA says even lower levels carry some risk and suggests considering a fix between 2 and 4 pCi/L. Plan to test again if you start using a lower level of the home, after major renovations, or sometime in the future.
What if my first short-term test is 4.0 pCi/L or higher?
Take a follow-up test before you decide what to do. EPA describes two options:
- Second short-term test: This gives a quick answer. Consider fixing your home if the average of the two tests is 4.0 pCi/L or higher.
- Long-term test: This better reflects your year-round average. Fix your home if the result is 4.0 pCi/L or higher.
Who can test my home for me?
You can use a mail-in kit yourself, or hire a qualified radon measurement professional. Your state radon program can help you find qualified professionals, and EPA recognizes two national proficiency programs, NRPP and NRSB. Our radon test kit guide explains where to find kits.
Sources
- EPA, A Citizen's Guide to Radon (PDF): EPA testing steps, test placement, closed-house conditions, and what test results mean.
- EPA, Home Buyer's and Seller's Guide to Radon (PDF, March 2024 revision): testing and fixing radon during a home sale.
- EPA, What is EPA's Action Level for Radon and What Does it Mean?: the 4 pCi/L action level, the 2 to 4 pCi/L range, and average indoor radon.
- EPA, Does the 2009 WHO recommendation affect EPA's action level?: how EPA describes the WHO reference level of 2.7 pCi/L.
- EPA, Find a Radon Test Kit or Measurement and Mitigation Professional: where to get test kits and how to find qualified radon service providers.
- EPA Radon: the U.S. EPA radon program page and starting point for testing, fixing, and radon zone information.
- CDC Radon: public health information on radon, testing, and reducing radon levels.
- WHO, Radon and health (fact sheet): the WHO reference level of 100 Bq/m3 (2.7 pCi/L) and international guidance.